what are 3 factors when selecting a contactor for a job?
Answer / shubhanand athalye
1)contactor current rating and duty (Eg AC-1,AC-3 etc)
should be suitable for load.
2) Contactor coil voltage shall be suitable / available.
3) contactor coil burden shall be minimum.
Is This Answer Correct ? | 4 Yes | 2 No |
what is DG synchronization panel plz explain the working!!!!!!!
12 Answers Kirloskar, Lanco, MPS Techologies, Sedemac,
What does a permanent magnet generator do?
What is ST and specify its range of voltage.
What are the applications of the electric motors?
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
what is bus PT ?
working principle of oil startar
what mean ohm
When we synchronize the Generator BKR with TIE BKR then Gen BKR is hold but TIE BKR is Tripped on Non directional over current but when TIE BKR is Syn. with Gen. BKR then no fault occur so what is the problem
Why, the starting current of 3 phase Induction Motor is 7 to 8 times its rated current?
fuses rated by amperes but not power,why?
What is power factor why we should maintain the power factor unless what will happen