Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

if in a level tx height is given, how u calculate the ranges of the tx?

2 Answers   Bombay Rayon Fashions, Invensys,

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

0 Answers   Chevron Phillips,

---

Can someone give a detailed chart on the temperature ranges which can be measured by various temperature sensors.

3 Answers  

---

What is the relationship between the universal gravitational constant (G) and the acceleration due to gravity (g)?

3 Answers   APPSC,

---

What are SMART insuments?

5 Answers  

---

Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.

0 Answers   Reddy Labs, ScienceWay,

---

What is the principle of capacitance type level transmitter?

0 Answers  

---

What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller

0 Answers  

---

i am confusing about differential pressure transmitter as i seen so many DPTs in different ranges how can we calculate level and flow with mmh20 plz tel me

1 Answers  

---

if i want buy a pressure gauge then witch parameter i look

2 Answers  

---

In separator VFD frequently trip with OVER VOLTAGE Fault What is the reason?

4 Answers  

---