A 3PH MOTOR RUNNING IN NORMAL CONDITION AND ITS AMPERE ALSO
UNDER ITS FULL LOAD CURRENT,ITS CABLE RATINGS ALSO HIGER
THN ITS CAPACITY,BUT ITS CABLE GETTING ABNORMAL HEAT(NOT
TOO HOT)WHY ITS GETTING HOT LIK THIS
Answers were Sorted based on User's Feedback
Cable quality may not be good or loose connection at the
terminals. If you earth the armour at both the ends there is
a likelihood
| Is This Answer Correct ? | 0 Yes | 0 No |
WHY IS CT SECONDARY SHORTED TOWRDS TH EQUIPMENT TO BE PROTECTED
WHY ARMAD USE IN CABLE
Do u know any one? how to find out in motor rated amps? formula?
Can I use 1 phase power supply to run 3 phase motor? If yes, how?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
Why the Transformer connection is changing in different transformer?(Like Star & Delta,Delta & Delta,Star & Star,Delta Star) From that connection where it is used?
How to calculate the cable size in sq. mm. when the load is given in KW?
Pl. give me checklist for installation & commissioning of machine tool.
How much width of the land shall have to be left below the EHT line of 440 kv as per the rule. i am told that a corridor of 35 M width is to be left free below 220 kv line. please confirm
What test must you do before powering up a circuit that you have been working on?
what is an S.C.R. and how do they work?
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)