what is the calculation of current when a clampmeter is
attached to two phases of any drives.
Answers were Sorted based on User's Feedback
Answer / pannir
vector sum of two line current would again gives the value
of line current flowing in each phase.
| Is This Answer Correct ? | 0 Yes | 3 No |
Why not using Air circuit breaker at High tension side?
What is the Difference Between resistance and resistivity?
What are the usege & different between UPS & batteries with charging system in in Substation?( UPS 120V AC & battery charger is 120v DC)
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
redundant connection in contactor?
In three phase supply why we use R Y B Colour not other.
Why NGR is required for 11Kv geneartor in power plant
if AVR fails in D.G set, what will be the effect?
in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected
what is the use of capacitor in online ups?
1.differance between onload ups and off line ups.
. Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)