if we use contactor & MCCB both in a feeder.in this feeder rating of conta

if we use contactor & MCCB both in a feeder.in this feeder
rating of contactor is higher or lower or same of MCCB
rating & why?

Question Posted / dolitomar27

1 Answers
3654 Views
I also Faced
E-Mail Answers

if we use contactor & MCCB both in a feeder.in this feeder rating of contactor is higher or lo..

Answer / k.prakashchandra

It is of no use if the settings of both is the same.The one
nearest to load should have a lower setting.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

In DC motor,the field MMF is given by NI.N-no.of field winding turns,I-excitation and both are constant.Then how could the main flux decreases due to armature reaction.

4 Answers Bhel, IBM,

What is Earth Fault and Over current Fault.

1 Answers

Why there is restriction to generated voltage to certain limit for example (now 18kv) ?

3 Answers College School Exams Tests,

bsec exam syllabus (mis)

0 Answers

This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.

0 Answers

The maximum demand of consumer is 2 kW and his daily energy consumption is 20 units. Its Load Factor is (1) 10.15% (2) 41.6 % (3) 50 % (4) 60%

2 Answers

what is the difference between earth and neutral?

1 Answers

How to select the ratio of neutral ct? Is there any relation in between percentage impedance and neutral ct ratio ?

1 Answers

Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18

0 Answers TCS,

Transformer diagram mention each parts ?

0 Answers

Why is transformer core is earthed

3 Answers

Dear All, If we have 8No. 11kV cables running underground that are required to supply 20MW to a new development. What is the sustained current in Amps? Please advise.

1 Answers

For more Electrical Engineering Interview Questions Click Here