why we are using the ac supply in domestic purpose why
don't use dc supply
Answers were Sorted based on User's Feedback
Answer / alif_motin
In power station ac power is generated and it is covenient
and easier to transmit and distribute ac power than dc power.
So most of the equipment are are designed for ac .So ac
supply in domestic purpose is mainly used .
Is This Answer Correct ? | 17 Yes | 4 No |
Answer / lakshmi narayanan
ac supply is coventional to use and cheap.if use dc supply
instead ac supply it is comparatively dangerous.maintainence
cost is high.dc equipments are economically high and need
much proper maintainence
Is This Answer Correct ? | 11 Yes | 2 No |
Answer / khushboo
in ac current flows in both cycle means synosoidal.but in
dc direct current flows which is hazadous.dc current is
harmful from safety point of view if it has to be used for
domestic purpose.for example if leakage current flows from
some applicance and if it is caught by human and if it is
dc than one can not not get rid of it as flow of current is
direct but if it is AC than one can get rid of it after
completion of cycle as it is alternate current so it is
less harmfull.
Is This Answer Correct ? | 11 Yes | 2 No |
Answer / sunil m
Ac supply is cheap and get easily but Dc suplly is costly
most of the motors ,equipment etc is working in AC so now
its not posible to change .In dc thevoltage is low .
Is This Answer Correct ? | 9 Yes | 6 No |
Answer / nil de
in ac supply u can easly avail the transformer action to increase or decrease voltage level but in dc u can't avail the transformer action.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / arif
ac is easy to generate & in every cycle the value of voltage
is change while dc give constant voltage and it is generate
by ac & so it also costly than ac.
Is This Answer Correct ? | 2 Yes | 3 No |
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
why we are using Load factor?
what is level 2 automation?
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
Why generating power limited to 11kv?
why VCB always installed only at HT yards or HT side? suppose if ACB installed at there means, what will be problem?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
sir i am pradeep singh from electrical branch and i want to place in software industry(tcs)but i dont know much about programmig languages like c c++.so how can i get a placement in software industry?
why substation ratings are multiple of 11 means 11\33 kv substation
Why generating voltage is limited up to 22kV?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
In DC motor,the field MMF is given by NI.N-no.of field winding turns,I-excitation and both are constant.Then how could the main flux decreases due to armature reaction.