Why did you leave your last job?

1 Answers   IBEX, Nikhil Comforts, Ranbaxy, Sabic,

---

What do you call the clearing of air inside cylinder after combustion?

1 Answers   RRB,

---

how to calculate bearing number to dia of the inner and outer

2 Answers   ABC, Horreia, Hyundai, Leoplast, MMM, PRAN-RFL, SKF,

---

what is routh,s law in thermal engineering ?

0 Answers   TATA,

---

What is the use of rasp file?

0 Answers  

---

What happen when the expansion valve is excessively open?

0 Answers   RRB,

---

1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers   Infotech,

---

which mechanism is used in automobile gearing system

9 Answers   Bosch, NTPC, TATA,

---

What is base design drawings?

0 Answers   JMC,

---

Steam is a vapour or a gas ?

7 Answers   BDL,

---

Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards

0 Answers  

---

I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons

0 Answers  

---