Answer / mrinal

DP type LT for more than 5000mm range.

What is difference between reset and initialization in industrial automation?

1 Answers   Marafiq,

---

what is the Difference betwee the Hart and smart series Pressure transmitter

1 Answers   HPCL Mittal Pipelines Limited HMEL, Kastech Instrumentation,

---

how can I install "operating system " in may HART communicator? It is damaged, and it doesn't boot up.

1 Answers   ARPC,

---

Please any one can explain how to calibrate transmitter (smart) online with out remove from the container suppose it is interface level or static pressure level measurement we dont want to remove transmitter from the container mean it is running plant please give me detail. thankx brothers

1 Answers   KNPC,

---

what is the diffirence between Earth and Neutral

4 Answers  

---

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers   QAFCO,

---

What are the advantages and benefits of using PLCs to automate a section of a plant?

2 Answers  

---

What are advantages and disadvantage of the ac supply load cell?

0 Answers  

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd

0 Answers  

---

what is the difference between active and passive loop ?

8 Answers  

---

Name four general (not technical) criteria that would you consider important, when deciding upon a particular control valve?

1 Answers  

---