Answer / k.prakashchandra

1.0 class is for measurement 1%- error at full load.Other
two are for protection. 5% error at 10 times the rated load
and 10% ---

Answer / k.prakashchandra

Wrt my reply ,please correct as '5% error in measurement and
capable of taking current 10 times the rated and so on'

Answer / harish kumar

actually cl is acuracy , means in what percent accuracy, cl 1, 0.5 is for metring purpose , and cl 5p 10 , ps , 10p10 is all for protection means for relay out put , means 5 % accuracy and 10 % accuracy

How to design CT for connected with Transformer OLTC operation? normally CT output design for 1A/5A range but during OLTC Tap position changing time how to function the CT?

1 Answers   HEG,

---

According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?

5 Answers   KEC,

---

where is the need for short circuit test for 3 see is required and why? can you explain in brief with application

0 Answers  

---

why America use 60HZ 110V?

4 Answers   Kalindee Rail,

---

function of soft starter .

2 Answers  

---

which network topology offers the greatest level of tolerance?

0 Answers  

---

we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards

0 Answers  

---

What is Partial Discharge test .Please specify that this test can be test on 11/0.433 KV,630 KVA Transformer.

1 Answers   NBCC,

---

What is an automatic controller?

0 Answers  

---

what is the relation between Sq mm of wire and its current carrying capacity?

5 Answers   Finolex,

---

what is the function of buchhos rely in transformer

5 Answers  

---

explain supply side and demand side energy management with advantages & disadvantages

0 Answers  

---