What is the difference between microprocessors and micro controllers?

What is the difference between microprocessors and micro
controllers?

Question Posted / anu$h@

4 Answers
5793 Views
CTS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the difference between microprocessors and micro controllers?..

Answer / manjima

microprocessor is a single chip cpu whereas microcontroller
is a single chip computer...

Is This Answer Correct ?

5 Yes

0 No

What is the difference between microprocessors and micro controllers?..

Answer / selvan

In microprocessor op codes are more, bit instruction is less
and in micro controller op codes are less, bit instruction
is more..

Is This Answer Correct ?

6 Yes

3 No

What is the difference between microprocessors and micro controllers?..

Answer / rahul

microprocessors are simple computers on a chip whereas micro
controllers consist of microprocessor,input/output devices &
a memory

Is This Answer Correct ?

5 Yes

2 No

What is the difference between microprocessors and micro controllers?..

Answer / monika

microcontroller is microprocessor with integrated
peripherals..

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

what is OpenBTS?

2 Answers

Define what is point contact diode?

0 Answers

In a sales interview if a person ask us how would you be able to sell our products in this recesion. How would i have to respond them.

0 Answers

can we conect lowpass filter before high pass filter in cascade form in band pass filter?(active filter).

0 Answers

which inert gas is flowing in tube light?

26 Answers Electronics, Philips, Reliance, TCS,

How to convert design gray to binary code?

0 Answers

Which of the following protection methods is NOT supported by FlexiHoppers with FIU19(E)?

0 Answers NSN,

As a water tank loses heat, the temperature drops by 2 K/min when a heater is on, the system gains temperature at 4 K/min. A two-position controller has a 0.5 min control lag and a neutral zone of ± 4% of the setpoint about a setpoint of 323 K. Plot the heater temperature versus time. Find the oscillation period

0 Answers Lafarge,

What are the advantages of ics over discrete component circuits?

0 Answers

Which is the fastest logic ?

0 Answers Lucent,

why we use 3point starter in dc motor why not 4point

1 Answers

In order to handle all combinations of input voltage polarities, a multiplier must have A Four-quadrant capability B Three- quadrant capability C Four inputs D Dual-supply voltages

0 Answers

For more Electronics Communications Interview Questions Click Here