what is voltage gradient?
Answers were Sorted based on User's Feedback
Answer / vijayarakavendran
The voltage per unit length along a resistor or other conductive path.
| Is This Answer Correct ? | 21 Yes | 5 No |
Answer / amit mohan bhatt
it is the potential diffrence per unit length its unit is
volt/m
| Is This Answer Correct ? | 7 Yes | 0 No |
Answer / ashish kamal
voltage gradient is simply electric field between two
point. it is basically used when we are discussing corona
loss
| Is This Answer Correct ? | 8 Yes | 4 No |
Answer / nitesh sharma
Aashish kamal: there is nothing related with corona effect, potential gradient simply is what mr. sunil das said that it is potential drop per unit length or potential difference per unit length. potential gradient is also known as CABLE RATING of XLPE /PVC cables. This potential drop or difference is depends many other factors like transmission voltage through the cable, cross section area of cables, temperature and also on the no. of runs of the cable to transmit the supply voltage etc etc.. This potential gradient is likely to be approx 2 or 2.5 but in the case of cables having smaller cross section area it is reached upto 4 or 4.8 but for the cables having larger cross section area we ignored this factor as it is approx 0.
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / bhagya
sir i cant understand clearly,pls tel me abt tat in detail
| Is This Answer Correct ? | 4 Yes | 5 No |
Answer / sathish
say any dangerous effects due to voltage graient,
and say any relation for current
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / radhey shyam mali
The ratio is potential difference between two charge and length between them.It is denoted by E.
E=dv/dl
| Is This Answer Correct ? | 0 Yes | 1 No |
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
what is the purpose of ignitor in lighting fixer
What is transformer break down voltage.And what is flash oil flash point.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
How to select the Cable size for 550 Amps Load without seeing the cable Catalogue?
What quedtion to ask a electrical maintenance technician?
5 Answers Bhel, Royal Furnishers,
if a number of plc s are there then how many modbus to be used
What will happen if the d.c. Machine is operated below rated speed?
what is RFCT and Insulgard Relay & It's function?
whis is the formula of converting KW into HP ?
What is lighting kitts.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)