why need of ac exietation in alternater.
Answers were Sorted based on User's Feedback
Answer / bkm
as we know whenever there is change in flux wmf will induce
so by this principle we can say that rotor is running at
synchronus speed and by exciting it we create north and
south pole permanantely on it now for two pole alternator
after each 180 degree rotation pole change their position
and thus change in flux occur which induce emf in stator
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / rabia
as the name symbolises altrnater means something which
alternates or make use of such technology. alternater or
transformer needs AC cycles that alternates with a certain
frequency to cause induction through electronagnetism in the
second coil.
| Is This Answer Correct ? | 0 Yes | 3 No |
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
difference between main metering kiosk and check metering kiosk
Why cables and busbar both needed in LT Panels?
In what circumstanced the CT used for protection relay will be saturated?and what will happen to the relay is the CT is saturated?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
I have 12MW gas engine based power plant its running parallel with grid. my problem is When cpp run in island mode(without geb) that time geb transformer power factor is 0.2 lagging. When cpp run with parallel that time power factor is 0.94 lagging So how can i maintain power factor ofgeb transformer in island mode 0.9 lagging?
what is wave trap? And how it works?
why power factor is only cosine angle not sine angle?
Why Trasformers rated in KVA
13 Answers College School Exams Tests, HAL, Oil and Gas Jobs,
We in my plant one of the transformer showing neutral to earth voltage is 22V how to solve it
Why synchronous motor is used in power factor improvement,dc series in lift
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)