voltage of a ckt is measured by volt meter having an input impedence camparabl

voltage of a ckt is measured by volt meter having an input
impedence camparable with the out put impedance of the ckt
Eror caused is
1. Gross Error
2. Errors due to lloading effect

Question Posted / sandeep

2 Answers
4279 Views
GATE, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

voltage of a ckt is measured by volt meter having an input impedence camparable with the out put i..

Answer / sandeep

though it seems errors is due to loading effect, it can be
Gross error also a it is misuse of the instrument. please
justify..

Is This Answer Correct ?

1 Yes

0 No

voltage of a ckt is measured by volt meter having an input impedence camparable with the out put i..

Answer / hrs

It is due to loading effect..if load is not connected to ckt
then current will not flow through it so input impedance
will not come in picture...

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is sevice settings for mccb?How can be it setted?

0 Answers Bhel, Minda,

why middle phase should used for earth fault and other phases used for over current in overcurrent and earth fault relay?

7 Answers ABB, ONGC,

Why in earthing, the earthing plate is put in vertical position? and further what is soft coke that is used in earthing?

3 Answers Wipro,

what are the different types of transformers in present? which transformer is efficient?

1 Answers TATA,

Explain thin film resistors and wire-wound resistors

0 Answers

What is meant by a stray loss of a induction motor??? What is the equation to find it

0 Answers

What happens if the capacitive reactance of a transmission line is very high?

5 Answers ABB, Power Grid,

Why the transmision line are 11,33,63,132kv?

10 Answers Power Grid,

how we can convert 3 phase to single phase without using any transformer

8 Answers

What is the better way of passing 400 amp from sending end to receiving end ? By overhead line or underground cable and why ? if underground cable then how much depth require ?

1 Answers Aditya Birla, HCL,

how to calclate fault level

2 Answers

What type of a DC motor would you use for a lift?

0 Answers GE,

For more Electrical Engineering Interview Questions Click Here