Why? We r used 50sq. mm. And above size cable in 3.5 core and below size are use

Why? We r used 50sq. mm. And above size cable in 3.5 core and below size are used in 4core

Question Posted / awaadhesh.999

2 Answers
4653 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why? We r used 50sq. mm. And above size cable in 3.5 core and below size are used in 4core..

Answer / k.prakashchandra

Above 50 sq mm cables are usually used 3 phase loads and
fair balancing of loads is expected.As the neutral current
is unlikely to exceed 50 % of full load ,half the core size
is sufficient to save money

Is This Answer Correct ?

2 Yes

0 No

Why? We r used 50sq. mm. And above size cable in 3.5 core and below size are used in 4core..

Answer / diwakar

We even have three phase loads used in 25 and 35 sq.mm.. cant say that as the reason alone.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

In pakistan appliances work on 220v at 50hz and in us appliances work on 110v at 60hz what is basic theory to explain it

1 Answers SNGPL,

how to convert lv line to hv line and viseversa, any losses will occur during this process

0 Answers Jindal,

Why in KVA diesel engine? Why not KW

3 Answers

What is ELCB?

9 Answers Bhel, CDS, IOCL,

WHY FLEXI LINKS ARE USED INBETWEEN GENERATOR TERMINAL OUTPUT & BUS DUCT CONDUCTOR.

3 Answers

Is it possible to power factor more than unity?

9 Answers BEL,

why output is out of phase in case of common emitter?

0 Answers

What is ferrite affects and what is disadvantage of ferrite affects.

1 Answers

I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions

0 Answers Wipro,

what is inrush current in transformer?

17 Answers Bhel, Essar, GMR,

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers

Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?

0 Answers

For more Electrical Engineering Interview Questions Click Here