What is the reason behind 11kv 33kv 132kv.....means
multiple of 11?
Answers were Sorted based on User's Feedback
They r depand the from factor and from factor =rms value/averag value=1.11 and they r pure sine wave.
| Is This Answer Correct ? | 30 Yes | 3 No |
Answer / ajit g. k.
We use sine wave in our electrical system. The form factor
of sine wave is 1.11 . For efficient transmission, we have
to maintain the generation and transmission voltage as a
multiple of 1.11 . This is the reason we use 11kV, 33kV.
The generation voltage is 11kV in India.
| Is This Answer Correct ? | 21 Yes | 2 No |
Answer / piyush kamani
11kv=11kilo Volts
Kilo = thousand multiply by
so 11kv = 11000 volts
| Is This Answer Correct ? | 12 Yes | 0 No |
Answer / komal jhala
11kv r 11000 kilo volt ,11000/1000=11kw ,20.9amps
| Is This Answer Correct ? | 5 Yes | 4 No |
Answer / engineer kaleem ullah
the most reasnable answr is that generation piont to end side of piont line voltage drops aproximate drop 10 then we sending 10 voltage extra like 100/110.......200/220......1000/1100
| Is This Answer Correct ? | 0 Yes | 2 No |
My system is 22kv/3.3kv transformer. client is asking to use NGR, but as we have dedicated Neutral Earthing systems which has a value less than 1 Ohm. So i want solid comparision. Why i should not use NGR as my system is already protected.Can any one help me to get out of this.how should i reply on basis of some great comparision and calculations. Please help
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
what is the working principle of induction motor
How will polarity test of Dy5 Transformer ?
Which are Electrical componet and Electronics componet??
which pump used in STP
we all know that in capacitor there will be no ay physical connection between the two electrodes of the capacitor ,and the charge is stored between these electrodes during charging , so with out any physical connection how these charge is transferred from one plate to the another plate during the discharge?????
What is the problem if we connect a weak capacitor to the system? is that profitable or Loss?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
What is turn ratio of a transformer?
why we are using panel space heaters in different control schemes????
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)