Answer / pillay

1 KW means 1000watts
The calculating equation for power is different for an AC
circuit and DC circuit.
FOR DC it is voltage x amps. That is to find out the
currents
value divide the watts by the voltage.
For AC single phase circuit it is voltage (V)x current (I) x
power factor (PF).

FOR ac 3 phase circuit it is root 3 x V x I X PF

So for a single phase cct of 240 v a 1KW Power and assuming
a PF of 0.8 will take

1000 divided by 240 and divided by 0.8 will give you the
amps

Answer / saju

Full load current =kw*1.78 so, 1.78A will take for 1kw

why HT motors are earthed only at equipment side & for it's single core cable with aluminium wire armoure using?

1 Answers   Legrand, NLC Neyveli Lignite Corporation Limited,

---

how to determine ct ratio in ht vcb?

0 Answers   Techno Engineering,

---

Why LED light has advantage of rapid reflection ,although other lights alse reflect.? and this light is considered to be best for transmission usage in case of Free optics

0 Answers  

---

What does the letter CTNM in negative phase sequence relay means?

0 Answers  

---

WHY IN WESTERN COUNTRIES THE ELECTRIC SHOCK IS VERY SLOW AS COMPARE TO INDIA.&IF ANY ONE HAVE CORRECT KNOWLEDGE THEN SEND OTHERWISE NOT

1 Answers  

---

Why sip ring used in ac motor also why its not used in dc motor?

2 Answers   RRB,

---

How we find the size of cable if we know the current

2 Answers   Gemscab,

---

If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?

0 Answers   Kirloskar,

---

Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.

0 Answers   TATA,

---

For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.

3 Answers  

---

What is the necessary condition for stability.

0 Answers  

---

What are the protection schemes used for protection of transformers ?

3 Answers   Engineers India Limited,

---