Answer / umeshmech

*the main funtion of fly wheel is to store energy (the
enegy which is comes from the crank shaft)
*when the speed becomes reduced it gives energy to crank
shaft and controls the change in speed
*another funtion is the to main tain the constent speedof
any machine,engine.........etc

Answer / yher

to serve as a momentum of the machine so that the machine
can maintain its desired speed. and if also the machine tend
to lower itself, the fly wheel will help to get back to its
original speed since the weight of the fly wheel is enough
to store the rotational energy needed to have a constant speed.

Answer / rakesh verma

flywheel will stores the energy that is produced during
power stroke and supplies energy to the crankshaft and other
rotating part during the rest of stroke .

Answer / khan taufeeque ahmed

The main function of the FLY WHEEL is to store energy and
supply this energy when the speed of the device is get
reduces to maintain its constant speed.

Answer / murali krishnan

The flywheel will stores the energy that is produced during
power stroke and supplies energy to the crankshaft and other
rotating part during the rest of stroke .
The energy stored in this flywheel is also used for other
component like A/C etc.

Answer / ram pratap yadav

flywheel will stores the energy that is produced during
power stroke and supplies energy to the crankshaft
during the other remaining three stroke .

Answer / sankar ganesh

the function of fly wheel is transmitting a power from crank
shaft to gear box.speed variations done by gear box only.fly
wheel rotates by stroke of piston.

Answer / rojin

Stores energy and gives it back to crankshaft when needed. Also helps in starting of vehicle... The teeths in flywheel help in that....

Answer / nani

The main function of FLY WHEEL is to store the energy and also
to supplied proper quantity energy.

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers  

What is the difference between hard water and soft water ?

1 Answers  

What is the profile of QA engineer

0 Answers   MAHINDRA,

Which bearings are used in the reciprocating compressor?

2 Answers   Manali Petrochemicals,

how gearbox ratio was calculated?

7 Answers   Reliance,

which network in india earning more turn over per annum

0 Answers  

Is it required slip & guide for incliened pipe installation to allow axial expansion. If yes, what type we have to use it

0 Answers   Al Inayah,

why is steam-water separation equipment so important in good boiler operation?

5 Answers  

are BS, BSP, BSW threads same?

0 Answers  

what is viscosity of fluid and what is the viscosity of grease and lubricating oil

2 Answers   Coca Cola,

why to work in oil industry

0 Answers  

Why centrifugal pump is not called as a positive displacement type of pump?

0 Answers