Answer / anil kamat

IT IS NOT CALL TAPITS BUT VALVE TAPPETS USED TO OPEN THE
VALVE USING VALVE MECHANISM (cAM SHAFT, pUSHROD , sPRING
AND TAPPET)

Answer / dhruv

Tappets for the engines are the guides for the valves which
are to be set according to the timing of the piston
movement such that max efficiency can be obtained while
compression stage.

Answer / rahul

i think tapit is the the part of cam mechanism which press
the valves

Answer / girish mahali

Tappets are mainly use in the engine,which is guide to the
two valve(inlet,out let)at disele cycle,it opperets the
disel cycle,which is situated over the head called rocker
box,to help the push rod ,which connet to the cam
saft,which opperate the governer,to spped controle.

I'm a first year student of B.E Mechanical Engineering... How should i prepare myself for getting selected in campus interviews from now itself...? What books should i refer....?

0 Answers  

---

Lowest temp in vapour compression cycle in :(Ans:Expansion devices) Contineous welding is type of :(Seam Welding) refrigerant in domestic Refrigerator:(R 134 A) Lowest critical temp of refrigerant:(Freon) Statement....this is .....law:(Avagadros law) Ratio reynold no to prandtl no is:(Pecelent no) if welding is done from right to left then what is the name welding:(Not known) slip gauges are made up of:(alloy steel) clearence between meeting surfaces is due to which gauges: question on rubby laser,rake angle,heat treatment processes,joules law,bell coleman cycle like a/c works on which cycle?

2 Answers   Hitachi,

---

Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?

0 Answers  

---

What are reasons for poor machinability for IS 2062 steel

0 Answers   L&T,

---

In running DG 2000 hrs, what are the maintenance work we will do.

2 Answers  

---

What is the formula for converting Pipe Diameter to Plate?

5 Answers  

---

Composition of bronze

4 Answers   Bhel, TVS,

---

what is the difference between simple air,steam and vapour ?

3 Answers  

---

Hi.. I am studying Mechanical Engineering.. And I am going to prepare for an interwiew of Caritor a software company.. so pleaz tell what i want to study in software and how I should prepare???

2 Answers  

---

DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?

3 Answers   Essar, Mecon,

---

Although the secondary loop of a PWR is a closed loop but some noncondensible gases are entrained into the secondary feedwater. Write three probable sources of these noncondensible gases.

1 Answers   Trinity Technologies,

---

Which reactor uses heavy water as moderator ?

0 Answers  

---