We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus

We have 420volts, Diesel gen-sets each 750kva 4nos. we are
operating with bus bar duct having 10x150mm for each face
4nos. our question is what is the minimum gap required
between each face? is there any satutory regulations?

Question Posted / ravindra babu j

1 Answers
3437 Views
Alliance One, I also Faced
E-Mail Answers

We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus bar duct having 10x1..

Answer / prakash

For Pahse to Phase - 30 to 50 mm
And For Phase to Neutral - 20 to 25 mm

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How do we calculate over and under frequency tolerance from generator data?

0 Answers DPS,

Is it necessary to seperate the DG earth grid with Electricity Board earth grid for protecting the DG set. if yes why?

2 Answers BARC,

I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.

0 Answers Jindal,

how to get bearing & winding temperature of an induction motor?

0 Answers

WHAT IS REACTIVE POWER?

2 Answers

What is the difference between Encoder and Resolver?

0 Answers DCCE,

125Kva Dg can take up how much amphere load.

7 Answers Indian Railways,

How can we measure the frequency of a rotor running in full load condition? Explain the method of measuring.

2 Answers Wipro,

Star Delta Diagram with full description