Answer / partha mitra

ICE(institute of civil engineering),check the website for
details.

How much percentage of overlap allowed in distribution steel as per IS Code.

2 Answers   Don Consult, India Cements,

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

What are Standard weights for concete of gradeM10,M15,M20,M25,M30 Etc.

1 Answers  

---

I Have concrete mix with 440kg opc and having 37 mpa strengh in 7days while in 28 days only 42mpa can anybody tell me the reason for the same.

4 Answers  

---

what r the precaution for high in atp tempareture,low in atp tempareture

0 Answers   NSL,

---

what is the maximum percentage of crush sand in mix design.also what is the difference betweeen grite powder & crush sand.

2 Answers   TATA, Vastu Kirti Enterprises,

---

How is the strength of cement measured?

0 Answers  

---

I need Bhel engineertrainy test papers in civil engineering please send to email id - hisandy66@gmail.com

0 Answers  

---

The designs required to construct a building are ––

1 Answers  

---

how many bags of cement,sand and Aggregate to p.c.c. of 1:2:4 ratio.

4 Answers   Isaac Designs,

---

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

0 Answers  

---

For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?

0 Answers  

---