Why beam breadth smaller than depth




Answers were Sorted based on User's Feedback



Why beam breadth smaller than depth..

Answer / shalender kumar

beam width smaller than depth because load bears more in vertically position as compare to flat as example of simple scale when we give the load it bends but when we give load on inverted scale it has no effect..

Is This Answer Correct ?    8 Yes 0 No

Why beam breadth smaller than depth..

Answer / b.rajendhar

section modulus increase with depth

Is This Answer Correct ?    1 Yes 0 No

Why beam breadth smaller than depth..

Answer / pankaj kumar gorai

A beam is a horizontal member in a structure. So, Greater the Depth more will it take the load as MI of the section increases with depth.

Is This Answer Correct ?    0 Yes 1 No




Why beam breadth smaller than depth..

Answer / aung pai

Normally, beam width is smaller than beam depth.Because beam width is connect to slab,that why slab can support any load together with beam width.

Is This Answer Correct ?    0 Yes 2 No

Post New Answer



More Civil Engineering Interview Questions

In 250x250mm cube, how much there will be cement,sand,water,and gravel

4 Answers   TATA,


Generally construction is based on which method:limit state of working stress

3 Answers   Mars Planning Engineering Services, Sterling Wilson,


what is a coupler and where do u use it ?

1 Answers   ITC Infotech,


Machine mix is better than hand mixing to get––

3 Answers  


What are types of mixs ?

3 Answers   L&T,






Cost control in civil construction as well as Quality control

11 Answers   Reliance,


silt%= silt volume/ silt+sand volume is this right?

0 Answers  


how calculate the bearing from two coordinates?

0 Answers   HPPCL Himachal Pradesh Power Corporation Limited, DPTL,


1)What is Suggested type of cement for concreting at water, for mass concreting and where the chaces of gettin attucked by salt? 2)How many types of camber? 3)why we always preffer short column in case of residential building? 4) Is there any advantages between the use of One way slab & two way slab? 5)What shoul be the % of steel for R. C. C. perpose based on volume & area ?

7 Answers   Gammon,


what if tie beams coming from x axis do not meet tie beam coming from y axis? Is it safe if they dont meet?

2 Answers  


Tell me about Construction, Contraction and Expansion joints...

2 Answers   Modi Builders, SMCC,


Types of column foundation and how to calculate its steel quantity.

0 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (4637)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3700)
  • Electrical Engineering Interview Questions Electrical Engineering (15770)
  • Electronics Communications Interview Questions Electronics Communications (2637)
  • Chemical Engineering Interview Questions Chemical Engineering (762)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (79)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (199)
  • Instrumentation Interview Questions Instrumentation (2879)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (41)
  • Marine Engineering Interview Questions Marine Engineering (62)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Engineering AllOther Interview Questions Engineering AllOther (1334)