why we get 2 differnet values for power factor in 2 watt
meter method in 3 phase
No Answer is Posted For this Question
Be the First to Post Answer
What are the types of bus duct?
Transformer type...??
which MPU register provides the address from which the next instruction byte is to be fetch?
why we are used D.c. voltage in L.T.side or controling side.we can use UPS also ,in place d.c. voltage
What is the difference between circuit breaker and isolator
how much watts the computer will takes
A three phase load, around 4 km away from the 11/0.433KV distribution transformer (Neutral of Transformer is solidily earthed) and consisting of mainly very costly and sensitive electronic equipments is giving trouble due to high voltage difference between neutral and body earth. Whether this problem can addressed by connecting neutral at the load point solidly to earth?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
in our transmisison sub station why we step down firstly 132kv\33kv then 33kv to 11kv. can we direct step down 132kv to 11kv.
how to check ac servo motor
125Kva Dg can take up how much amphere load.
We have 2 Nos. Transformer with the capacity of 2000KVA and 1250 KVA and currently using only one 2000KVA T/R during operational hours while non- operational hous 1250 KVA T/R also used to reduce T & D losses. Similarly, 2 capacitor bank of 500KVAR and 300 KVAR also installed to balance reactive power. Now problem is around 1000 KW load PF is not maintaning 0.99 as 350 KVAR capacitor is in healty condtion. Now the PF is maintain 0.95 to 0.96.