why we use lamination or layer by layer cor used?

Question Posted / guest

4 Answers
6049 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we use lamination or layer by layer cor used?..

Answer / guest

in order to reduce eddy currents

Is This Answer Correct ?

4 Yes

0 No

why we use lamination or layer by layer cor used?..

Answer / ashish saxena

To reduce eddey current losses

Is This Answer Correct ?

4 Yes

0 No

why we use lamination or layer by layer cor used?..

Answer / gautham sharma

We use laminated metalic plates to make the cores of transformers and electric motos and many other things. This is to avoid energy loss in the form of Eddy Current. Eddy current are circular loops of current which form conductind plates or surfaces which can result energy loss in the form of heat. Laminated cores increase the resistance by a substantial amount and reduces eddy current.

Is This Answer Correct ?

1 Yes

0 No

why we use lamination or layer by layer cor used?..

Answer / prasad.v

to avoid leakage of flux

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details

0 Answers

What is the formula to calculate the rating of a thermal over load relay

2 Answers

how is calculated the quantity of weight in hot test xlpe?

0 Answers Hirbodan,

what is IP55,IP65

4 Answers

Motor also having losses, we call KW rating. In transformer and generator having losses but we call KVA Rating why?

9 Answers

Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?

2 Answers

Differentiate between digital phase converter and ordinary phase converter.

0 Answers

Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com

0 Answers

Why earthing is required for diesel tank?

4 Answers Greaves,

Why Transistors are not used as switching devices?

15 Answers

what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)

2 Answers

any earth foult trip the relay but in welding time not trip by earth foult

0 Answers Power Grid, Siemens,

For more Electrical Engineering Interview Questions Click Here