what is bus coupler, where it used.

Question Posted / guest

14 Answers
86145 Views
Diebold, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is bus coupler, where it used. ..

Answer / dr mukesh kumar

In case failure of circuit breaker to open from Main Switch Board busbar when isolating generator this bus tie breaker will isolate that section of MSB to safe guard the prime mover from mechanical damage, as in such situation motoring action will take place in generator.

Is This Answer Correct ?

0 Yes

0 No

what is bus coupler, where it used. ..

Answer / m.chaitanyasreekar

Bus coupler we using we have give directly supply why it was happend and bus coupler is copper or iron

Is This Answer Correct ?

1 Yes

3 No

what is bus coupler, where it used. ..

Answer / venkatesh

two or more buses can connect a common bus called bus
coupler. it s used in transmission

Is This Answer Correct ?

11 Yes

22 No

what is bus coupler, where it used. ..

Answer / meeran

The bus coupler use only connect the two bus bar. Bus bar
length will go more then 3 meter or our required length that
area we are using bus coupler.

Is This Answer Correct ?

5 Yes

17 No

Post New Answer

More Electrical Engineering Interview Questions

Why we use shunt coil in breaker??????????

7 Answers

what is mean by amf

4 Answers Siemens,

why the voltage and current in a long transmission line are called travelling wave?

0 Answers UIU,

How to calculate the current capacity of the 3C / 1C Al/Cu power cable???

2 Answers

i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.

0 Answers

Why don't we provide SURGE ARRESTORS for Transformer feeders?

5 Answers

when we connect a CT in the line will there be any loses in the line due to the mutual inductance of the CT.

1 Answers

Which Machine u will prefer to use at a place where flammable gases are coming out & why ?

4 Answers NTPC,

What are various impedence in any machine

2 Answers Engineers India Limited, NTPC,

Our transformer capacity is 500kva & voltage ratio is 11kv/433v step down tf.Now i need to know if my input voltage is 10500v and what would be the secondary side voltage i.e output voltage ?

3 Answers Helma,

How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?

0 Answers

what is the differents and advantages of Electro magnetics relay and static relay ? what is the numerical relay ? advatages?......

7 Answers CAT, L&T, TCS,

For more Electrical Engineering Interview Questions Click Here