Answer / che pin

As previous answer. When the tank full with low sg fluid it
is 0% level. And when the tank is full with higher sg fluid
it is 100% level

Answer / vikash

First fill the tank full with lowspecific gravity fluid and
adjust it to zero .then fill the tank full with high
specific gravity fluid then adjust the span of the
transmitter.

I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.

0 Answers  

---

What are different types of orifice plates? State their uses.

0 Answers  

---

what effects a surging can produce in the compressor

0 Answers   Nemat,

---

please explain smoke detectore & lel detector?what is o/p

1 Answers  

---

What is the purpose of MATLAB?

3 Answers  

---

why we are using magnet for calibration of gas detector?

0 Answers   NSH,

---

what is burner management system?

2 Answers   Alstom,

---

which are types of orifice tap ?

2 Answers  

---

d/p flow transmitter LP side give to pressure.what you geting out put ? how you get(ma)?

6 Answers   ABB,

---

when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?

0 Answers  

---

How to control flow variations in magnetic flow maters..... When i will provide proper earthing?

0 Answers   ABB, L&T,

---

Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

0 Answers   CCIE,

---