Answer / ashish gupta

Although the density of free electrons around the positive conductor is less as compared to negative conductor but the electrons are highly concentrated around the curved surface of the positive conductor and hence for same energy that has to be dissipated in corona, the activation energy require to enegerize the electrons to take part in corona will be less in case of positive conductor as compared to negative conductor.
hence due to participation of large no. of high energy electrons around positive conductor in corona as compared to negative polarity we can say that corona losses are higher in positive conductor as compared to negative conductor.
Contact: ashishguptaa164@gmail.com

Answer / sri krishna

corona loss is obviously less when compared to the poztv
polarity or (phase)
to understand this we have to know the corona phenomenon,
the air surrounding the HT OR HV conductor gets ionized due
the high potential (nd skin effect also) and this ionised
air also acts as conducting medium, hence the losses okkurs
there. but koming to the negative polarity, the voltage is
very less hence the ionisation of the air surrounding is
very less (comparatively),, henc the corona loss is minimum
with ngtv polarity.

any queries regarding this plz kontakt srikrishna_2020@yahoo.com

Answer / sri krishna

corona loss is obviously less when compared to the poztv
polarity or (phase)
to understand this we have to know the corona phenomenon,
the air surrounding the HT OR HV conductor gets ionized due
the high potential (nd skin effect also) and this ionised
air also acts as conducting medium, hence the losses okkurs
there. but koming to the negative polarity, the voltage is
very less hence the ionisation of the air surrounding is
very less (comparatively),, henc the corona loss is minimum
with ngtv polarity.

any queries regarding this plz kontakt srikrishna_2020@yahoo.com

If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.

0 Answers  

---

whether choke act as a voltage regulator in tubelight or not?

1 Answers   Bhel,

---

can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

11 Answers   Philips,

---

why exciter frequency 150 Hz ?

1 Answers   Siemens,

---

We are using Powerica make 100 KVA DG set. Whenever i connect compressor on DG load (Compressor Make Atlas Copco 5.5 kva) that time we face the lot of fluctuation on Dg output. Can you please suggest me how can prevent this fluctuation?

6 Answers  

---

assume we are put both df/dt and vector surge relay in same bus the df/dt relay setting is +5 hz an -5HZ. we want operat the vector surge relay before the df/dt how i calculate the setting of the vector surge relay.

1 Answers  

---

why is efficiency of transformer more than that of other rotating machines?

1 Answers  

---

What is the difference between Derived earth Fault and measured earth fault.How it works.

1 Answers  

---

what the good value of earth resistance test

3 Answers  

---

pleasee tell me the risks and hazards of a Cable Jointer job? Thank you.

1 Answers  

---

What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?

1 Answers  

---

What is Automatic Voltage regulator(AVR)?

6 Answers   Cummins,

---