Answer / salil

Servo Motor is one which functions based on the feedback it
receives from comparator and other feedback devices for
accurate functioning, in both the directon. it is used as
control device. In trains, traction motors are used,
normally are d.c. series motors.

Answer / bhagya

ACTUALLY SERVOMOTOR MEANS IT WILL ROTATE WITH SOME ANGLE,IN
ELECTRICAL TRAINS THE PURPOSE OF THE SERVOMOTOR IS TO LIFT
THE PANTOGRAPH WITH SOME ANGLE TO TOUCH WITH THE CONTACT
WIRE...DC SERIES MOTORS ARE USED IN ELECTRICAL TRAINS

Answer / ramasamyseenu

servo motor is the motor which just converts the rotational movement of one motor into the same equivalent rotational motion of another motor, It has a servo transmitter and servo receiver and amplifier unit and also a error correction and sensing unit(which actually senses and corrects the error in servo receiver side). For example if you rotate the knob present in the servo transmitter by some angle say 120 degree, the same amount of rotation can be obtained in servo receiver and if any error occurs it is corrected by the error ckt. the operation can be clockwise or anti-clockwise direction i.e in receiver side it can be able to rotate same as transmitter rotation or in opposite direction rotation of transmitter rotation in order to perform opposite direction rotation you just have to reverse any two of the 3 phase supply i.e connect the ryb of transmitter side with either rby or yrb connection. realtime example of servomotor is in radar in order to locate the position of the radar.
under the train compartment dc series motors are used

Answer / arjun

Servo Motor is one which functions based on the feedback it
receives from Encoder and other feedback devices for
accurate functioning.

In trains we use Series Motor as trains has to start with
the load.

Answer / anoop.pk

In trains, I think there are no motors. Only generators are
used.

if we want to convert the two 12 V DC batteries in parallel for UPS ? what would be the result ? which is better for a UPS , connect two batteries in series or connect them in parallel ?

2 Answers  

---

we all know that in transformer, voltage and current are inversely related i.e. Vp/Vs= Is/Ip....so in standard CT..we have a ratio of 200/5...that means our voltage should increase by ratio of 40..althoug that is not the case...because that requires high insulation level.and pratically not feasible......can anybody clarify my ques.......thanx

2 Answers  

---

i have 3500 amp load and select current transformer and perches.how i calculate .please understand

1 Answers  

---

Why cannot we insulate HT over head cable to avoid ionization of air around the HT Cable?..By this we can minimise corona loss also..

1 Answers  

---

name of good resistance material

1 Answers  

---

What is meant by celling voltage & current in excitor ?

1 Answers  

---

What is Bolted fault?

1 Answers  

---

How the over load setting for HT Motors calculated-provided in Numerical Relay

1 Answers   Damodar Valley Corporation,

---

What is the Difference Between resistance and resistivity?

2 Answers   Sun Pharma,

---

How Can we calculate the rating of a cable?Show the formula?

2 Answers   Jindal,

---

What is the diff. between two phase & three phase supply.

7 Answers   Crompton Greaves,

---

why diesel tank is earthed

1 Answers   ABB, NTPC,

---