WHAT IS MINIMUM AMOUNT OF CURRENT THE HUMAN BEING CANT
RECOVER FROM THE SHOCK,WHAT IS THE RESISTANCE OF THE HUMAN
BODY
Answers were Sorted based on User's Feedback
26 milli ampers of current
the resistense would vary from person to person. but avg
value of the resistence is 1000OHMs
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / shaul hamid
The perception of electric shock can be different depending
on the voltage, duration, current, path taken, frequency,
etc. Current entering the hand has a threshold of perception
of about 5 to 10 milliamperes (mA) for DC and about 1 to 10
mA for AC at 60 Hz. Shock perception declines with
increasing frequency, ultimately disappearing at frequencies
above 15-20 kHz.
| Is This Answer Correct ? | 0 Yes | 0 No |
The threshhold value of current than can make a person numb
is 27 milli amps. In my opinion the resistance would vary
from person to person
| Is This Answer Correct ? | 2 Yes | 3 No |
Why usually in all electrical equipment taking more current in Y pahse like pumps,compressor,or any other applications
Is there any problem if i connect APFC panel in generator circuit
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
what is the difference between phase and neutral?
3 Answers IAF, Indian Airlines,
what is the difference between induction and synchronous motor?explain in simple words?why 3 phase motor is given preference over single phase motor.
what maximum load will take a aluminum cable of 50mm 4 core.
What is the function of semicon in 33kv ht cable ?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
what is the effect of higher value of GD???
what is negative d.c. voltage, why this voltage is used in base transciever station.
WHAT IS THE DIFFERENCE BETWEEN SHOP DRAWINGS/ DESIGN DRAWINGS AND AS BUILT DRAWINGS??
2 Answers ACC, Al-Jaber, Dubai Group, ECEC,
how one can check the Current of a DC 12 V battery ? Procedure. I told that take a thick wire (having more wires in it) and then join the + and - terminals of battery with the help of two ends of a thick wire .... is this correct or wrong .....
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)