Answer / k.prakashchandra

The load is reduced.As the stability is to be established
,the load becomes equal to generation at the lower
frequency, within limits.

What is neutral earth voltage of transformer and what should be the value

3 Answers  

---

Diffrectiate between earthing and neutral

6 Answers   TATA,

---

Why we not use the impedance relay in protection of short transmission line ?

4 Answers  

---

One Township having 850 house and each house load is 2.2KW single phase & 5HP 3 Phase motors of 10 Nos .Who can calculate 11 KV transformer capacity .dilip_bhasker@yahoo.co.in

1 Answers  

---

how to calculate cable bending angle in a trench?

2 Answers   Eastern Cement,

---

How to connected to energy meter, pt, ct, ammeter, voltmeter and selector switch.

1 Answers   Omplas,

---

10Hp, 3-phase, 415v, 50Hz induction motor. The above motor is to run on Star-Delta connection, so how do i make following hardware selection 1) MCB, 2) Contactor, 3) Wire Gage (Depending on P-P current or Line Current), 4) OLR, Please tell in detail how to do the above, so as to get the ans. of it even if the Hp rating changes.

1 Answers   Engro,

---

what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)

2 Answers  

---

design a 3 bit synchronous and asynchronous counter using T- flipflop

0 Answers  

---

What is the purpose of starter and choke in tube light?

9 Answers   Chimay Brewery, TATA, TSPL,

---

Can we use droop CT in neutral in place of W phase of alternator ?

2 Answers  

---

What are the different power system losses and how can it be eliminated?

0 Answers  

---