Answer / bala_vlsi

As per you statment
300 / 230x0.8= 1.7 A
2.2 a is in worest condition generally 200 VA consider
for one workstation . one w/s means one monitor and one CPU

Answer / bala_vlsi

As per you statment
300 / 230x0.8= 1.7 A
2.2 a is in worest condition generally 200 VA consider
for one workstation . one w/s means one monitor and one CPU

Answer / k.prakashchandra

I think that it is written as 2.2 A max.The monitor has a
tube warming heater which automatically switches off as the
required temp is reached.

BRIEFELY EXPLAIN MEGGAR PRINCIPLE

2 Answers  

---

what would happen nif we increase or decrease the capacitor of a flood light.

1 Answers  

---

Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)

0 Answers  

---

What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?

0 Answers  

---

how to carried out DAR test in 11 KV Alternator ?

0 Answers  

---

What is majour reason of Electrical Arcing ?

9 Answers   ABB,

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

how to make a solar panel? why solar panel cell connected to serious?

1 Answers  

---

why America use 60HZ 110V?

4 Answers   Kalindee Rail,

---

How to decide the rating of CBCT? We have 6.6Kv switchgear & having 50/1 cbct ,i want to know how this 50/1 A came? On what basis we decide CBCT reting?

1 Answers   Cross,

---

is a normal conductor can be used a core in windings if not what is the winding core speciality.

2 Answers  

---

What is mean by staling?

2 Answers   UPPCL,

---