Why Water motor is not taking a load or pressure while everything is correct.
(Note: Motor running properly)
No Answer is Posted For this Question
Be the First to Post Answer
What should be the setting of an earth fault relay.
What is the difference between MPP, APP, Mixed Dielectric power capacitors? Which technology is superior in current scenario?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
can we use NPT glands in LT panel
10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL FAULTS IS ........
Ammeter of 1 ohm resistance measure max 10 ohm to measure higher resistance from it
how to connect from a line-to-line connection to a line-to- neutral connection?
what is the difference between the electrical and electronic choke?
why transformer not used to starter
In power plants the reading changes abruptly to give value (MW -25) (MVAR -15) What are the reasons for this? What is the solution?
how the characterstics of control valve being done
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)