How to covert the ac to dc and how to control the dc output?

Question Posted / yousef

3 Answers
6701 Views
ABB, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How to covert the ac to dc and how to control the dc output?..

Answer / manikandan

by using rectifier we can convert ac to dc and by using
choke or capacitor filter we can control dc output

Is This Answer Correct ?

7 Yes

3 No

How to covert the ac to dc and how to control the dc output?..

Answer / gopal

rectifire is used to convert the ac in to dc but the
rectifier are to types according to voltage level.for low
voltage diode are used as a rectfire,we cannt control the
output of diode,in high voltage system SCR thyristor are
used as a rectifire,we can control the DC output of the
thyristor.

Is This Answer Correct ?

6 Yes

3 No

How to covert the ac to dc and how to control the dc output?..

Answer / apoorv

we can easily convert ac to dc by using rectifiers or diodes. dc output can be controlled by usingphase controlled rectifiers , which employ scr's. by properly trigering scr's , with proper firing angles, and commutation circuitry, dc voltage , can be controlled.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?

0 Answers

why single induction motor is not self starter?

3 Answers

How to check AC & DC Choke

1 Answers

Wat is the best to use in a generator a 6.5kva or a 7 kw

4 Answers

check list of maintenance of transformer?

11 Answers ABC, Cosmos, EPRON, Essar, Godrej, Hescom, Infosys, KPTCL, TCS,

WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?

1 Answers

how to control the generator output voltage? what r the condition should satisfy for synchronization?

7 Answers HP,

In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.

0 Answers

Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend

0 Answers

what r the earthing required for commissioning of D.G set?

5 Answers

What is a parabolic signal?

0 Answers

one 60KVA UPS how can full load current tell me us formulas

1 Answers Wipro,

For more Electrical Engineering Interview Questions Click Here