Interested to Buy Any Domain ? << Click Here >> for more details...
differentiate different units of pressure like US & UK
standards
- 1 Answers
- 3911 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
There are some difference in some areas like "area" in sq
feet and tons of force but nothing that concern us in
instrumentation. PSI is PSI all over the world and so is all
other units of measure we use in instrumentation. The UOM
that are slightly different between US and UK is not of any
importance to us.
All of these difference are also in the imperial system and
there are no differences when you work in the metric system.
In the area of pressure specifically, there is only the ton
of force that are only 1,2 more than the other and that is
not something you will ever use. The same is true for all
other UOM for temp, flow, level, density and all the ones we
use.
Good luck
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where proximity sensor installed on tank in loading arm application
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
what will the sending unit in the fuel gauge utilizes?
What are different type of instrument cable
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
Where is wet leg is used?
Why is the orifice tab provided?
How does temperature bath work? How does coil gets heated only by applying some current?
ORP sensor working principle?
What is the purpose of LO Overhead tank in turbines.
How to calibrate Toxic gas detector?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
How do you identify an orifice in the pipeline?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Do you have reference list?
