what is the diffrence between resistive load and
capoasitive load.?
Answers were Sorted based on User's Feedback
Answer / amit
in pure resistive load,the load will consume only the
active power and there will be no reactive power ......
in capacitive load the reactive power will be supplied to
the network by the load as the current will lead the
voltage by 90 degres..
Is This Answer Correct ? | 9 Yes | 0 No |
Answer / jagadeeshraja.m
In Resistive load the angle between Voltage(E) & Current
(I)are in phase to each other, (ie,..) COS 0 = 1. So power
factor is always unity.
In Capacitive load, Current Leads the Voltage by the angle
of COS @.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / natarajan ramkumar
Resistive load R=Phase angle Zero
Capacitive load Xc=Phase angle leading.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / pandu
the power factor is equal to zero is called resistive load
the power factor is ledding is called capactive load
Is This Answer Correct ? | 0 Yes | 4 No |
Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV,20kV, 30kV?
if vcb make contact but output notreach give the reason?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
EARTH AND NEUTRAL ARE JOINTED OR NOT?
can you use 400 volt 3 phase and neutral and earth equipment on 440 3 phase and earth supply safely and if so how?
Draw a SLD for main panel for school having connected load of 1200kw and emergency generator 200kw.also show the increase of additional load of chiller 225kw in the lv panel indicating meter postion size of transformer ,cables and capacitor bank.
When we are working on transformer(132\11KV). we are going to isolate the transformer from both HV side and LV side. then we are applying grounding on both side. My question is that we required to isolate the VT which is still connected from secondary side.?
how does bode plot have an advantage over root locus? how does it determine the stability of a system depending upon the location of poles and zeroes?
what is direct dischage of power transformer
A current of 2A flows for 10 hour through a 100 ohm resistor. The energy consumed by the resistor is:(a) 0.5 kWh(b) 4 kWh(c) 2 kWh(d) 0.02 kWh
iam interesting to design the control panel for 3 phase pump motors by controling single phase switches.iam plan to use fuse,contactor & relay for motor protection .how can i select the voltage & amps rating for fuse,contactor & relay plz guide me .if anybody clarify my doubt means it will more helpful for my future .
why no load voltage is greater than full load voltage?