Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between resistive load and
capoasitive load.?
- 4 Answers
- 6808 Views
- I also Faced
- E-Mail Answers
Answer Posted / natarajan ramkumar
Resistive load R=Phase angle Zero
Capacitive load Xc=Phase angle leading.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is protection class current transformer.
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
how we find transformer capacity by ohm
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
Mention the disadvantages of low power factor? How can it be improved?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
While converting delta into star or star into delta ,the three values of resistances remains unchanged .Find out the value?Let In star R1=x;r2=x;R3=x On converting into delta,R12=x;R23=x;R31=x Find the value of x
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
How calculated single phase induction motor req. Capacitor?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
What is meant by vector group
what are the applications of PLC?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
How to design harmonic filter at the project stage without nowing the harmonics levels
