What is the voltage b/w nutral and earth
Answers were Sorted based on User's Feedback
Answer / irfan hussain memon
in balanced condition both neutral and earth has 0
potentional voltage.
| Is This Answer Correct ? | 9 Yes | 1 No |
Answer / bhavneet kumar surya roshni lt
Should be less than 2volt for
low load.
And for heavy load less than
5volt.
| Is This Answer Correct ? | 7 Yes | 3 No |
Answer / shaddan shahjahanpuri
न्यूट्रल और अर्थ के बीच वोल्टेज 0 वोल्ट होता है
यदि लोड सन्तुलित है
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / sreekumar
earth to nutral voltage depends on the impedence of the
winding of transformer(distribution transformer) for normal
case there is a small current flowing through the nutral to
earth because of the unbalance in phase voltage/current.it
depends on the impdence of winding.
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / om
earth is a refference voltage and assuming as a zero voltage
while nutral is commone point of any ckt or network it may
be zero or any value so it may be zero or may not be zero
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / parvesh1989
0.001 OHM,
because when a body is earth, its attains a zero potential
or potential of earth.
Another answer is 0 to 4 volt properly.
| Is This Answer Correct ? | 1 Yes | 3 No |
Answer / kravi
Good earth voltage is zero
for bad earth is .......
| Is This Answer Correct ? | 2 Yes | 7 No |
what is the affect of earth's magnetic field on the frequency used in aircraft???
How to find Cable size? Caterpillar generator produce (Two generators) 127*2=254 amp at 11 kv . What would be the cable size (XLPE) to supply 256 amp at 11 kv? Air or surrounding Temperature is 32 degree C. Cable will go under ground at 2.5 feet depth. Group Rating Factors is 3 cables. Clearance between cables is 7 cm. Soil Temperature (Ambient) 28o C Soil Thermal Resistivity is 1.2 K.m/W I would like to use 3 separate single core instead of using 3 core cable. Some says I should use three separate single core 120RM cables. Some says 70RM .some says 95. I m totally confused. Is there ant specific rule to determine cable size? What would be the LT cable size to flow 500 Amp current? Ifte My e mail address is ifte13@yahoo.com Anyone please send me the answer to my e mail address, i will be very glad.
what is function of rtu?
What happens when the polarity changes in CT? Explain briefly?
how to avoid Saturation in C.T?
can any one know is sbi interview based on merit or based on roll number
What are the condition for parallel operation of transformers?
what is an isolation transformer??? what is its purpose??? what happens if it is not used where it should be used?????
Is there any thumb rule for cable selection for any current rating ?
what is consequences of neutral and earth connect?
1.Is there any difference between terminologies,HT-HV <- LV? 2.What is the highest transmission voltage level in india?
What would be the size of wire used for 2 Ton of window A.C?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)