DESIGN PROCEDURE OF THE COLUMNS
No Answer is Posted For this Question
Be the First to Post Answer
Tell me about triple point of water.
Why provide strripus in a column minimum and maximum spacing.
What is cement-concrete ratio ?
shape of aggregates used in concrete should be rounded/cubical or elongated/flaky.
What is the strength of 150x150mm cube compared to 300x300mm concrete cube?? Why?
please give me the rates of RCC(CUM), PCC(CUM), Brick Work(CUM), Tile Flooring, Saria Shuttering
WHAT IS YOUR FUTURE PLANS FOR THE COMPANY IF PERMANENTLY EMPLOYED
wat is the optimum mix design for M25 grade of concrete ? is the ratio 1:1.5:3.65 correct?
Brick is fire resistant than stone because––
why we provide plastic sheet under lean concrete/pcc.?
for columns reinforcement the lap length is not provided then how to rebar the rods then how rebar should be lapped
4 Answers Nagarjuna Construction,
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)