why we use vsb transmission for video signal transmission
and why dont we use ssb transmission?
Answers were Sorted based on User's Feedback
Answer / devendra krishna
we use it because in Vsb Xmission a part containing
information more than one sideband is transmitted & in that
extra part, information regarding low frequency components
of colours of video signal exists.While in SSB Xmission this
part is supressed so lower frequency components of colour is
supressed..
| Is This Answer Correct ? | 9 Yes | 1 No |
Answer / salini
Actually the video signal contains significant low frequencies which when modulated using ssb will be filtered out and reconstruction is not possible. Using vsb modulation will help to retain the lower frequency component during the reconstruction of the video signal.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / guest
IN ssb transmission the freqency is not sufficient for
video signal transmission.the video signal ranges from 6khz
to 24khz.
| Is This Answer Correct ? | 4 Yes | 3 No |
Answer / buddha pradeep
Vsb has been used for video signal transmission because the video signal having a bandwidth of 0 to 4.5 mhz if we use
Am and dsb then the amount of bandwidth would be 9 mhz(2fm)
Which is practically impracticable . If we use ssb the spectral gap for video signal is o hz and there may lose of information takes palce in ssb.
So vsb has been used
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / ishant jain
actually generation os ssb is difficult as well as costly
than vsb so due to this vsb transmission is preffered.
ISHANT JAIN
G.L.A UNIVERSITY
| Is This Answer Correct ? | 0 Yes | 5 No |
Answer / abhay sunder
simply becoz of low cost incase of vestigial sidebands otherwise ssb can also do the same work........
| Is This Answer Correct ? | 3 Yes | 11 No |
what is the difference between 2G and 3G network?
what is meant by communication?
What is the relation between current and voltage?
the configure that is worst effected by ?
HI, i am jayakumar, a B.E graduate of ECE. i have applied for officer trainee written test exam which is going to be conducted by hindustan petroleum corporation limited. currently the writen test of it, has been postponed from febuary to someother day without releasing the date. i am searching for question related to the writen test that whould be asked during the event of the test. if you possess the questions, pls email it to this id jai_pkp81@yahoo.co.in
What is a mosfet? How is it different from a jfet? What are its typical applications?
What are d uses of a diode . What is diode equation . And what is its use
2 Answers Bosch, Infosys, Siemens,
Give examples for Micro controller?
why number of scanning lines per frame always odd in television?
WT is technical detail and Function or working of these cards 1. POWER CARDS 2. BB2F 3. Trx 4. BOIA CARD 5. ALARM EXTENSION SYSTEM 6. RRI CARD 7. COMBINER 8. DUPLEXER
Hiiii....Friends Which one is right? 1.All transducers are sensors but all sensors are not transducers.(or) 2.All sensors are transducers but all transducers are not sensors..... Plzzzz tel me guys...thank u in advance...
WHAT IS THE DIFFERENCE BETWEEN ABSOLUTE ENCODER AND INCREMENTAL ENCODER.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)