Product of three consecutive nos. 210. What is the sum of two least numbers?4 9024
If the area of the sqaure is increased by 69 % how much the length of the side will increase?1 11889
if the sum of five consecutive nos. 35? how many prime nos are there ?5 13107
if the length of the rectangle is reduced by 20% and breath is increased by 20 % what is the net change ?2 4065
If there are too many page faults what is the problem?2 8158
To ensure one pgm. doesnt corrupt other pgm. in a Multi-pgm. enviornment .what you should do?2 4092
Which one is not needed for Multi-pgm. enviornment?1 2872
Which one is not done by Data link layer ? bit stuffing, LRC,CRC,parity check1 3798
int a=1,b=2,c=3; printf("%d,%d",a,b,c); What is the output?14 17534
if length of a rectangle is incr by 20% and width is decr by 20% then area5 20188
the lead in pencil is 5inch long.after pieces of 1/8.1-3/4,1-1/12 inches are broken how long is the lead left in the pencil?1 2876
how many two digit numbers satisfy the property:the last digit of the sqr of the two digit number is 82 8475
what is the max no of points of intersection of two circles of unequal radii7 12800
if the area of sqare increases by 69% then side of the sqr incr by5 4971
Can anyone send me question papers for section engineer for railways and send me on my id- email@example.com
Which of the Following problems can be modeled as CSP? a) 8-Puzzle problem b) 8-Queen problem c) Map coloring problem d) Sudoku
Explain the situation where you have applied SCD in your project?
What is the difference between Michell type bearing and anti friction bearing and the application.
could you please post some work around that any body have done in the financial modules.
What is maximum continuos Rating?
wht can u do for the growth of bhel?
interview questions with answer for cts
what should be the components of a fair policy with regard to collecting, maintaining, and dissemination information about employees?
What is good accounts Process & Execution capabilities?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
Tell me about Your Past Live experience / Project
wht is difference b/ osi & tcp/ip model
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
How to run the converter for visual studio IDE?