Are mechanical seals in pumps direction specified?
Answers were Sorted based on User's Feedback
Answer / mayank jansari
yes,the direction is specified as per design and flow
requirement.inlet or outlet its basis on type of pume.
Is This Answer Correct ? | 16 Yes | 1 No |
Answer / ram
i cant understand ur que... wiil i give it in more
explained manner i will give u all about mech
seals ......to me nothing ibn direction of seals
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / nihar ranjan
No not required because it does not work on the ratchet principle.
Is This Answer Correct ? | 1 Yes | 4 No |
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
WHY DOES LORRY TANKERS DESINGNED TO BE IN SPHERICAL(CURVED,ROUND), WHY DOESNOT IT DESIGNED TO BE AS SQUARE OR REACTANGLE IN SHAPE.
5 Answers APSRTC, Schlumberger,
what is sight glass, water level meter, water level indicator, level control probe?
What pressure is highest L.O. Gravity Head or S.W. of the stern tube circulation
what is accilaration
What do you understand by sulphur print ?
how to calculate pressure drop in air ducting
i am going to face interview of hal so plz any body send me the sample questions of hal .... plz reply to girish.salaga2@gmail.com
If any machinery or transmission needs periodic ana regular lubrication . what is the best method to give it?
Why is heat treatment required?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........