What will happen if cold water is poured on the Barrel (Used for oil storage)

What will happen if cold water is poured on the Barrel
(Used for oil storage) filled with water vapour.

Question Posted / nilesh

4 Answers
5236 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What will happen if cold water is poured on the Barrel (Used for oil storage) filled with water va..

Answer / praveen upadhyay

heat will be transfered from vapour in barrel to cold water
logic:heat transferes from higher temperature to lower
temperature so vapour will convert to water

Is This Answer Correct ?

4 Yes

0 No

What will happen if cold water is poured on the Barrel (Used for oil storage) filled with water va..

Answer / arvind yeram

heat will get transfer from the cold water to the vapour in
order to create vapour into water.

Is This Answer Correct ?

2 Yes

1 No

What will happen if cold water is poured on the Barrel (Used for oil storage) filled with water va..

Answer / and

the barrel may collapse under external air pressure

Is This Answer Correct ?

1 Yes

0 No

What will happen if cold water is poured on the Barrel (Used for oil storage) filled with water va..

Answer / nilesh

But what is the effect on the Barrel container.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

Does the rate increase by experience or number of years worked?

0 Answers

What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?

0 Answers

What happens when too much cylinder oil is injected in the working cylinder?

0 Answers

We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

0 Answers PetroVietnam,

what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?

0 Answers Voltas,

i am very much confused about direction of thrust in steam turbine...we have steam turbine of 13 stages,10 stages of impulse and 3 of reaction type....in study manual direction of thrust is towards inlet but on thrust bearing its loading side is towards condenser(exhaust side) wile also dummy ring is present in design which also restrict rotor to move in exhaust side direction not inlet ....

2 Answers

what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?

0 Answers GE, ONGC,

Accelerometers measure acceleration. How do you measure the moment of inertia?

0 Answers

Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)

0 Answers Bhel,

How do you reset the circuit breaker?

0 Answers RRB,

Out of electric heater and heat pump, which is economical in operation ?

0 Answers

What is the trunk type and crosshead type piston

0 Answers RRB,

For more Mechanical Engineering Interview Questions Click Here