Answer / santosh89

I think its working is same as ordinary low rating CTs of same class.......because in split core CT we only split or open or break the core so that as per our requirement the no. of primary windings or copper plate can enter inside into the core.

i have a Connected Load of 280KW and Maximum Demand of 224KW to one of SMDB under design with me. which criteria should i consider to design panel and main cables connected Load or Maximum Demand 1)Breaker rating 2)Panel Busbar rating 2)Incommer cable sizing (ignore Voltage drop)

1 Answers  

---

How to know the back up time for a 5KVA UPS which is connected to 15 nos. of computers? Is there any formula for this? pls. tell me.

1 Answers   S V Sugar,

---

What are the causes for the failures of sandwich type (Al) busducts?

0 Answers  

---

why ac current do not save

3 Answers  

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

0 Answers  

---

What is difference between MCC,PMCC,PDB?

2 Answers   Cipla, JSW,

---

why we use 3 phase in our country?..why no 4,5 or 2??

2 Answers   Siemens,

---

when an induction motor runs on load.at that time if we reduce the supply voltage the current increases.But when it runs without load,if we reduce the supply voltage the current also reduced.why?.i checked it practically also.

1 Answers   Birla,

---

How to convert a two phase power into a three phase power in induction machine?

0 Answers  

---

what is meant by negative sequencing in power system.explain in detail

1 Answers  

---

why do we connect droop ct{in gensets}in y_phase only

2 Answers  

---

What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance

0 Answers  

---