its Kva and Kv are same?
Answers were Sorted based on User's Feedback
KV is kilo-volt, whereas KVA stands for kilo-volt-ampere.
Kilo volt means the potential difference measured between
two points. Kilo volt ampere is the actual power consumed
by the electrical load.this is apparent power and vectorial
sum of kw and kvar
Is This Answer Correct ? | 28 Yes | 0 No |
Answer / arulkumaran
NO,
KVA = KV*AMPERE
KV = Kilo volt
KVA = Kilo volt ampere
if KVA is not consumed the power factor.transformer
only mention the the KVA.
Is This Answer Correct ? | 0 Yes | 0 No |
why do we use LPF wattmeter not UPF in the experiment of no load and blocked rotor test of 3phase slipring induction motor?
what is the minimum distance between substation wall and LT panel outer surface?
why there is a temperature rise at different metal to metal contact at cable lug??suppose cable is aluminium and the lug is copper,than why the temperature rise takes place??
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..
what are all the components required to assemble solar panel other than pv cell?
What is super thermal power plant? and how it will differ from normal thermal power plant
what are the highly demanded courses for electrical engg. who finished his b.tech
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
When we synchronize the Generator BKR with TIE BKR then Gen BKR is hold but TIE BKR is Tripped on Non directional over current but when TIE BKR is Syn. with Gen. BKR then no fault occur so what is the problem
The loads are connected with phase and ground then why current flow as the loads ?
What are the complete specifications of a motor?.