Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sam
Use in steam boilers as the auto control sequence (DCS or
PLC controlled) for the various gas or oil burners.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
what is the reason while warning lamp is on while the engine is cranking?
Why we are using reverse action in displacer types level transmitters on some Vessels?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How to Calibrate Flammable gas detector in field
How is automatic reference junction compensation carried out in temperature recorders?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
defination of radial vibration?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
can you send remote seal interface level transmitter calculation steps for oil water saperator.
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
what is the difference between -24 : +24 & 0:24 and where it use?
Describe how to use megger to measure the earth resistance and insulation resistance
How to calculate mmwc values into tonnes?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
