Answer Posted / jeyaganesh.g
The Ejection System is used to remove the part from the
core and cavity,
the ejection system includes, ejector pin ,
this system always mounted from core side.
Ejector system also can designed in design
level.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
What do you understand by timed cylinder lubrication ?
"When you will install a new piston ring, what will be the position of it?"
what is line balancing
Explain the principle of Suizer Fuel oil injection pump
where is the steam trap connected in boiler distribution?
What is jet plane?
what is jdbc bridge?
Describe the different cold drawing processes.
What is the formula for 1 HP of a two-cycle engine?
Which reactor has no moderator ?
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
what is Retainer?
What is the mathed of maintain oxizen level in a air tite A/c room.
why it is difficult to make heavy cuts if a form turning tool is complex in shape?