Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...


Given a ckt,the max power dissipated in the load ZL ?



Given a ckt,the max power dissipated in the load ZL ?..

Answer / shubham

maximum power transfer takes place in any ckt when load is
equal to the equivalent thevenin's impedence of that ckt.
But in such situation efficiency of the circuit is highly
reduced

Is This Answer Correct ?    2 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

Why stones are layed under Transformer

4 Answers  


how to make neutral to ground voltage less than 5v? my house is under the high voltage transmission line so,proper grounding using rod salt n coal doesnt help me..so wat i do as i cant operate my computer ..this high voltage cause great problem to the motherboard i already two times replaced it.in my house voltage is coming near to 25 v between ground and neutral.plz kindly post ur answer to my email id manish77777@gmail.com ..

3 Answers  


Why at the starting of induction motor current is high?

5 Answers  


IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.

0 Answers  


how to check the 3ph capacitor is good or not.

14 Answers   MacLellan, Yash Technologies,






draw 3 phase rectifier diagram

0 Answers   Equate,


synchronous motor of 13.5MW having which type protection? and how to set relay?give me relay setting calculation for different protection for this motor assume efficiency,power factor and other term if neccecery

1 Answers  


why do we use LPF wattmeter not UPF in the experiment of no load and blocked rotor test of 3phase slipring induction motor?

3 Answers   Matrix,


Which system is best for industries 3ph 3w or 3ph 4w?

3 Answers  


What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers  


what is the difference between earth and neutral?

56 Answers   Bhel, Emerson, HCL, JLL, L&T, Siemens, TVS,


what are the different methods for the starting of a synchronous motor.

0 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (5074)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4444)
  • Electrical Engineering Interview Questions Electrical Engineering (16594)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1092)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (258)
  • Instrumentation Interview Questions Instrumentation (2986)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (123)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1377)