Answer / rao

Due to generator winding insulation problem

Answer / k.prakashchandra

Insulation

Answer / n.bharat mohan

generally a high voltage is transmitted to incure the losses, so as to reach the desired voltege at the end consumer.To obtain these high voltages we prefer transformers during the trasmission of power instead of generating a high voltage.
generally it is not preferred to generate because when we prefer a 11KV generation we require a huge amount of design and large cost is preferred instead of it we can prefer a method to obtain a high voltage is by using transformer.

In case of motor Power Factor Generally We Apply A Capacitor But How Can We Know That A Motor is Running On Very low Power Factor And What Rating Of Capacitor We Have To Place And Tell Me Conversion Of Micro Farad to KVAR>

2 Answers  

---

What are the different lines and what are the different types of losses occur on them?

2 Answers  

---

Why the transformers are rated in KVA. ? in new view.

2 Answers  

---

if sf6 gas low in gis what will happen

0 Answers  

---

if our motor load is 150 amp v- kv and we want to install capacitor bank then what is the exact value of that capacitor bank that we should install?and how we calculate that

0 Answers  

---

In case of 3Phase Supply, Voltage R-Earth/Neutral - 220 Y-Earth/Neutral - 220 Z-Earth/Neutral - 220 Total is -> 660Volts Then Why it is said that 3Phase supply is 440

6 Answers   Hindustan Unilever Limited,

---

what is the main difference between simplex RTD and Duplex RTD?

6 Answers  

---

AVR is used for the Voltage regulation of the Generator using the feedback signal by exciting the field winding of the generator.But how the field winding will be excited & using what?

2 Answers   Alstom,

---

What is the minimum distance between MV busbare (P to P & P to E) as per some standards

1 Answers   ABB, Sejong,

---

Three phase power is measured with two wattmeeter for balance three phase load.the reading of one wattmeter is zero.we can conclude that the power factor of balance load is?

1 Answers  

---

Where to use pt and where to use CVT

2 Answers  

---

Why mostly the HV side of transformer has Delta?

0 Answers  

---