Answer / sunil ulange hit

INDOOR SUBSTATION MEANS THE SUBSTAIONS THAT WE KEPT INSIDE
THE ANY BULDINGS, HALLS

OUTDOOR SUBSTATION MEANS THE SUBSTATION THAT WE KEFT OUSIDE
PLACE MEANS BARRONS, DESERTS..ETC
AND THESE ARE DESIGNED CONSIDERING IP PREOTECTION.ie WATER
PROTECTION, DUST PROTECTION.. ie IP 54, IP55

Answer / jyothi

Indoor substation is a substation this is constructed in
side the building and this is used below 11kv.
Out door substation is substation this is constructed in
open areas(large areas0.and this is used above 11kv.

Answer / somasundaram.t

IN indoor substations the substation equipments are kept
inside the closed environment or buildings whereas in the
outdoor substation the substation equipments are kept in
open environment or opened surroundings.

Answer / raikripashankar

IN indoor substations equipments are kept
inside the closed environment or buildings whereas the
outdoor substation tequipments are kept in
open environment or opened surroundings.

Answer / balaji

1.Indoor substation means underground substation,outdoor
substation means above the ground.
2.purpose to go for indoor substation is less space
available for erection of substation.so we can use SF6 gas
as insulating medium in indoor substaion to reduce
space,instead of using normal insulation.but cost is high
for erection of indoor substation.

what mean by machin

5 Answers  

---

basic priniciple of induction motor

2 Answers   Electronics, Ramco,

---

HRC fuse provide best protection against

3 Answers  

---

what is cathodic protaction?

1 Answers  

---

why a single phase motor of same rating takes more amps than the three phase motor? as single phase motor at 230v takes 5amp per HP while 3 p motor takes 2.5amp per hp at 230v.

1 Answers  

---

Whats difference between a single phase & a three phase motor?

4 Answers  

---

HOE WE CAN IMPROOVE BY USE OF CAPACITOR

1 Answers  

---

What is difference between stable and steady?

1 Answers  

---

which %age if losses increases when frequency is increased to 25%

4 Answers   Maihar Cement, Siemens,

---

dear all, in motor operation , motor is of 100 hp and bimetal relay setting is 130 amp, if relay is getting tripped on 120 amp balance current what can be the reason? Relay is newly replaced. I dont know but is there any frequency effect in thit case? Can frequency variation affect bimetal relay operation?

1 Answers  

---

How to calculate the copper in HT motors if KW, RPM & Voltage is given

1 Answers   Control Dynamics, NTPC,

---

what is earthed and inearthed cable or system?

1 Answers   CCCL, L&T,

---