Answer / iamdon

Yes.

Coal based power palnt is established at the site of coal
centres(mines).Modern trend is of coal based power plant.
Since now we are well advanced in electrical technology and
also we dont want to be affected with transportaion
problem.So the choice is obvious.

Load based power plants are established at the load centres
(industries).This was earlier choice of thermal power
plants so as to reduce transmission cost as we were in
intial stage of technology.The major difficuly with load
based power plant was frequent transportation problem.
Author:arbelectbit@yahoo.com

why we have to do tan delta test of the transformer oil???

5 Answers  

---

ac and dc motor advandtage,disadvantage,aplication

2 Answers   Apollo,

---

FOR 3 PHASE DISTRIBUTION,WHY WE USE ONLY THE VOLTAGE LEVEL OF 440 VOLTS

1 Answers   AITM,

---

super position theorem is applicable to

1 Answers  

---

what happen if steam turbine trip,g.c.b not open and excitation off and on condition?

1 Answers  

---

---

Why temperature rise is conducted in bus bars and isolators?

0 Answers  

---

why the no.of slots in stator in not equal to the no. of stator in rotor in induction motor????

4 Answers   Jindal,

---

Between rotating armature type and rotating field type arrangements which one is adopted for large rated alternators and DC generators.Why there is difference in the choice?

1 Answers  

---

which protection function should measure RMS value of current&DFT value of current?

0 Answers  

---

When the load on the system is zero and Capacitor bank is on condition, is capacitor bank takes any load?

2 Answers  

---

A wattmeter is marked 15 A/30A, 300V/600V and its scale is marked up to 4500 watt. When the meter is connected for 30A, 1600V, the pointer indicates 2000 watts. The actual power in the circuit in

1 Answers   Jindal,

---

If one d.g. is unable to take full load of system, then second d.g. will take care of partly Load.for this condition RPM of both DG set should be equal.By using Synchronization panel RPM of dg sets are match, is it true?

1 Answers  

---