Is there any difference between load based power plant and
coal based power plant?
Answer Posted / iamdon
Yes.
Coal based power palnt is established at the site of coal
centres(mines).Modern trend is of coal based power plant.
Since now we are well advanced in electrical technology and
also we dont want to be affected with transportaion
problem.So the choice is obvious.
Load based power plants are established at the load centres
(industries).This was earlier choice of thermal power
plants so as to reduce transmission cost as we were in
intial stage of technology.The major difficuly with load
based power plant was frequent transportation problem.
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to size H.T & L.T Panel ?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
What does ampere turns shows?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
Purpose of providing neutral isolation panel for parallel operation of diesel generator
how is the testing of an REF relay? what are the test REF circuit having?
What will be in Mahagenco Trade Test Exam? I want to know the same.
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
why d.c produces corrosion
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
What happen in ups if phase reverse?
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.